3D models

Anna's block in full detail: a lifestyle-block 3D model

This is the full-detail model of Anna's lifestyle block in Taranaki, built from 1,301 drone photos taken in mapping grids at four heights, with its fine texture from the lowest flight, 25 m above the ground, at 0.77 cm per pixel: the sharpest ground detail we get from mapping flights alone. Because it was flown from above, you will notice blur up under the eaves, where the drone could not see. This kind of model suits larger areas, such as lifestyle blocks of about 1 to 20 acres: good detail without excessive time on site, which keeps the cost economical, and we can add closer-up detail wherever it is needed. It has been cut to the area we flew at 25 m, with the neighbouring properties masked out. Choose a measuring tool and click on the model.

Map system · NZGD2000 / NZTM2000, heights NZVD2016 (positions are not shown for this private property)

Explore and measure it

Choose a tool, then click points on the model. Undo removes the last point, Cancel drops the measurement in progress, and Clear removes every measurement. Each finished measurement is added to the list under the model.

The position tool (eastings, northings and elevation) has been removed from this model for client privacy.

Depending on your internet connection, you may have to wait a few seconds for the texture to sharpen as you move around. The model streams in small pieces, so the part you are looking at loads first; the readout under the model says when detail is still loading.

How to measure

  • Distance — click two points. You get the straight-line distance, the horizontal distance (as it would be on a map), the height difference, and the slope.
  • Height — click two points to get only the height difference between them, the way a builder's level would.
  • Angle — click three points; the second click is the corner. You get the angle at the corner, and the angle as seen from above where that differs.
  • Area — click the corners in order, then press Finish (or click the first corner again). On level ground you get the area as it would be drawn on a map; on a wall, roof or slope you get its true surface area and how steep it is, as well as its map area. You also get the distance round the edge and each side's length. A shape whose edges cross is refused.
  • Moving around — left-drag to move, right-drag or middle-drag to turn, scroll to zoom; or use the buttons at the left of the model. The house button returns to the start view.
  • Accuracy tip — zoom in and look at the surface you are measuring face-on. A point clicked on a surface seen at a shallow, glancing angle can land a little way along it, because one screen pixel covers more ground there.

What the model can and cannot tell you

This is the full-detail model, not simplified for the web, streamed in pieces so the page starts quickly. The centimetres shown in a measurement are the display resolution, not a guarantee of accuracy, so zoom in, click on a clear edge, and keep to hard surfaces where you can.

Look closely at the trees and you will notice a few patches that have not built quite right: holes, or pieces of canopy with nothing under them. Leaves move in the wind between photos, so the software cannot find the same point in the same place in every photo, and where it is that uncertain it leaves a hole rather than guess. Geomap NZ is prototyping a robotic SLAM LiDAR scanner with RTK positioning to fill in these places from the ground.

Heights are differences only

To protect a private property, this model is shown without its real position, so it gives distances, height differences, angles and areas but not coordinates or heights above sea level. The full model we supply to a client carries both, in NZTM2000 with NZVD2016 heights.

Back to the 3D models

Need your place mapped from the air?

Tell us about your land and we'll take it from take-off to finished map.

Get in touch