3D models

Drone 3D models you can explore and measure

Three Taranaki sites built into 3D from drone photos: Joe Gibbs Reserve at Inglewood at full detail, Anna's lifestyle block, and the Ōkato cheese factory as a high-specification industrial inspection model. All of them can be measured in your browser.

Map system · NZGD2000 / NZTM2000, heights NZVD2016

Joe Gibbs Reserve, Inglewood: native bush returning

New Plymouth District Council has replaced two hectares of old pines at Joe Gibbs Reserve with native bush. With the council's approval, we flew the reserve as a baseline to measure the regeneration against. The model streams at full detail, sits on a map of the area if you want one, and can be measured: distance, height, slope, angle, area and position.

Open the Joe Gibbs Reserve model

Drone 3D model of Joe Gibbs Reserve, Inglewood, Taranaki, seen from above: the cleared ground where the pines stood, native bush along the gully, pasture, sheds and shelter belts

Anna's block: lifestyle-block detail at an economical scale

Our sharpest ground detail from mapping flights alone: Anna's lifestyle block was flown in mapping grids at four heights, and the model's texture comes from the lowest flight, 25 m above the ground, at 0.77 cm per pixel. Because it was flown from above, you will notice blur up under the eaves, where the drone could not see. This kind of model suits larger areas, such as lifestyle blocks of about 1 to 20 acres: good detail without excessive time on site, which keeps the cost economical, with closer-up detail added wherever it is needed. It streams at full detail, cut to the area we flew at 25 m with the neighbouring properties masked out, and can be measured: distance, height, slope, angle and area.

Open Anna's block in full detail

Full-detail drone 3D model of Anna's lifestyle block in Taranaki: paddocks, the house and sheds, the bush gully and the planted hillside

Ōkato cheese factory: 3D industrial inspection

Our most detailed model yet: 1,838 drone photos built into 40 million triangles and 2.1 billion pixels of texture, with the walls, eaves, pipework and roofs all in full detail. Pan round it, inspect its condition and measure it in map coordinates.

Open the Ōkato cheese factory model

3D inspection model of the Ōkato cheese factory: a covered passage between buildings with rusting steel posts, pipework along the walls and corrugated roofs with flues

Need your place mapped from the air?

Tell us about your land and we'll take it from take-off to finished map.

Get in touch